V-Tec 2-wire Manual de usuario

Busca en linea o descarga Manual de usuario para Sistemas de intercomunicación de la puerta V-Tec 2-wire. Boomslang Fabrication Manual de usuario

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 6
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 0
Boomslang Fabrication
OBD0 to OBD1 Conversion Harness Installation Instructions
Version 1.5
Parts needed for this conversion - MPFI and DPFI vehicles
OBD1 or OBD2 distributor that fits your engine
Distributor connector (engine harness side)
OBD1 or OBD2 Honda/Acura 4-wire oxygen (O2) sensor
4-wire oxygen sensor connector (engine harness side)
OBD1 ECU
VTEC, IAB, and knock sensor connectors (engine harness side)
if applicable to your engine/ECU combination
Additional parts needed if converting a stock DPFI vehicle to OBD1
Four fuel injectors that are properly sized for your ECU
Fuel injector resistor box if using low impedence fuel injectors
Four fuel injector connectors that fit your fuel injectors
MPFI Models DPFI Models
88-91 CRX Si and HF 88-91 CRX DX
88-91 Civic Si 88-91 Civic DX and Std
88-91 Integra
You must use the proper conversion harness type on your
vehicle. MPFI conversion harnesses WILL NOT work on DPFI
vehicles and vice versa.
If your DPFI vehicle has been previously converted to MPFI, then
use a MPFI conversion harness.
MPFI conversion harnesses have a sub-harness with an 8-
position white connector.
DPFI conversion harnesses have a sub-harness with an 8-
position and a 4-position white connector.
Vista de pagina 0
1 2 3 4 5 6

Indice de contenidos

Pagina 1 - Version 1.5

Boomslang Fabrication OBD0 to OBD1 Conversion Harness Installation Instructions Version 1.5 Parts needed for this conversion - MPFI and DPFI vehicl

Pagina 2

Important notes on OBD0 and OBD1 fuel injection differences • You may use low impedence type fuel injectors with an OBD1 ECU but you MUST use a fact

Pagina 3

Conversion Harness Installation Details 1) Disconnect the negative terminal of the battery. Plug the conversion harness into the factory ECU plu

Pagina 4

• Connect the green wire in the supplied sub-harness to the green/yellow wire on the 1-pin VTEC solenoid connector. • Connect the light blue wire i

Pagina 5

• Splice the red wire to the red wire on the #2 fuel injector connector. • Splice the blue wire coming from the black connector on the supplied su

Pagina 6

Wire Color FunctionWire Color FunctionLight Green VTEC Solenoid SignalPink IAB - Secondary Intake Runners Brown #1 Fuel InjectorLight Blue VTEC Oil Pr

Comentarios a estos manuales

Sin comentarios