V-Tec DT592 Manual de usuario descargar pdf (Pagina 12)

-10-

6.Setup

6.2 DIP Switches Settings of Monitor

6.1 DIP Switches Settings of Doorstation

Total 2 bits on the DIP switches can be congured.The switches can be modied either before or after

installation.

Bit state Descriptions

Default setting, ID = 0(00), set to the rst Door Station.

ID = 1(10), set to the second Door Station.

ID = 2(01), set to the third Door Station.

ID = 3(11), set to the fourth Door Station.

1 2

There are 6 bit switches in total. The DIP switches are used to configure the User Code for each

Monitor.

ON(1)

OFF(0)

Bit-6 is used to set video impedance,it should be set to ON if the Monitor is in the end of the line(bus),

otherwise set to OFF.

Bit state Setting Bit state Setting

The monitor is

not at the end

of the bus.

The monitor

is at the end

of the bus.

1 2 3 4 5 6

1 2 ... 7 8 9 10 11 12 13 14 15 16

Sin comentarios

V-Tec DT592 Manual de usuario Pagina 12