V-Tec 2-wire Manual de usuario descargar pdf (Pagina 28)

SFC-VTEC Main Menu

Functions●

Compatibility List & Wiring Diagrams●

Basic Introduction●

Testing and Mode Switching●

How to use the SFC-mode (fuel mapping)●

How to use the VTEC-mode●

How to use the Speedo & Speed Limit removal●

Other Functions●

Troubleshooting●

SFC-VTEC Wiring for H1 Cars

Compatible Cars (H1) Chassis Type Engine Name Year Model ECU Location

CR-X EF8 B16A 9/89 ~ 3/92 Foot area of Passenger-side seat

Integra DA6, DA8 B16A 4/89 ~ 9/91 Foot area of Passenger-side seat

Civic EF9 B16A 9/89 ~ 9/91 Foot area of Passenger-side seat

Instructions:

Turn off the Engine, and remove the (-) negative ground from your battery1.

Remove all covers, etc., and locate your ECU2.

Following the diagram below, wire your unit accordingly.3.

Use pliers to securely fasten the electrotaps.

❍

Use proper crimping tools to fasten the terminals securely.❍

If you see wire that originally had a ring-shaped connector, please make sure that it gets

properly grounded.

❍

On some models, there will be wires that are not used, or left disconnected. Please use

electrical tape to terminate properly.

❍

Once the wiring is complete, set the dipswitches to the following configuration, and install the unit in

your desired location.

Re-connect your battery terminal, and confirm operation of the device.6.

SFC-VTEC Wiring for H1 Cars

http://asia.vtec.net/beystock/field/sfc-vtec/x01_sfcv0h1.html (1 von 2) [06.07.2000 22:48:18]

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 34 35

Sin comentarios

V-Tec 2-wire Manual de usuario Pagina 28