V-Tec 2-wire Especificaciones descargar pdf (Pagina 12)

-485

SET

485

SET

Door Station Lock Connections

+12V T/R -

LK - (GND)

T/R+

LK+(COM)

N.O.

EB+

EB -

DMR11

Connection Board

+12 VLK - (G ND)

T/ R - T/ R +

LK +( CO M) N. O. E B +E B -

L1 L2

2 3

BUS

1. Direct lock connection

L1 L2

3 PB

BUS

Use the power of the system to supply for the electronic lock, so that the lock can connect to the Door Station directly,

without an additional power supply for the electronic lock. Note that the Door Station can only output a 12Vdc power;

therefore the kind of lock used is limited.

•

The rated power of the lock must be less than 12Vdc 300mA when using direct lock connection method.

The GND must connect to the negative of the lock, and the COM connects to the positive.

Jumper set to 1-2 position for Power-to-Unlock safety type; set to 2-3 position for Power-off-to -Unlock type(in

this case the Unlock Relay mode should be set to Normally Closed on DT CONFIG software)

The 5th bit of the DIP switches is for the unlocking time setting, its set to off by default, for 1 second unlocking

time. If set this bit to on, the unlocking time is 5 seconds.

If different unlocking time is needed to be configured, the DT CONFIG software can be used to change the

Unlock Timing on the Parameter tab(see the program section).

A. Connection for Power-to-Unlock type:

+12V

DIPS

LK - (GND)

LK+(COM)

N.O.

1 2 3 4 5 6

EB+

12V 300mA

EB -

Jumper set to 1-2 position

DIPS-5: default set to off,

unlocking time is 1 second.

(In most cases, 1 second is

work for Power-to-Unlock type)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 51 52

Comentarios a estos manuales

Sin comentarios

V-Tec 2-wire Especificaciones Pagina 12

Comentarios a estos manuales

Relacionado con productos y manuales para Sistemas de intercomunicación de la puerta V-Tec 2-wire