V-Tec AT16/C5 Especificaciones Pagina 44
- Pagina / 94
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Si2400
44 Rev. 1.3
S17 0x17 BTOF Busy tone off. Time that the busy tone must be off (10 ms units)
for busy tone detector.
0x32
S18 0x18 BTOD Busy tone delta. Detector Time Delta (10 ms). A busy tone is
detected to be valid if (BTON – BTOD < on time < BTON +
BTOD) and (BTOF – BTOD < off time < BTOF + BTOD).
0x0F
S19 0x19 RTON Ringback tone on. Time that the ringback tone must be on
(53.333 ms units) for ringback tone detector.
0x26
S1A 0x1A RTOF Ringback tone off. Time that the ringback tone must be off
(53.333 ms units) for ringback tone detector.
0x4B
S1B 0x1B RTOD Detector time delta (53.333 ms units). A ringback tone is deter-
mined to be valid if (RTON – RTOD < on time < RTON + RTOD)
and (RTOF – RTOD < off time < RTOF + RTOD).
0x07
S1C 0x1C DTT Dial tone detect time. The time that the dial tone must be valid
before being detected
(10 ms units).
0x0A
S1D 0x1D DTMFD DTMF detect time. The time that a DTMF tone must be valid
before being detected (10 ms units).
0x03
S1E 0x1E TATL Transmit answer tone length. Answer tone length in seconds
when answering a call (1 second units).
0x03
S1F 0x1F ATTD Answer tone to transmit delay. Delay between answer tone end
and transmit data start (5/3 ms units). In the !7 mode, this is a bit-
mapped register.
0x2D
S20 0x20 UNL Unscrambled ones length. Minimum length of time required for
detection of unscrambled binary ones during V.22 handshaking
by a calling modem (5/3 ms units).
0x5D
S21 0x21 TSOD Transmit scrambled ones delay. Time between unscrambled
binary one detection and scrambled binary one transmission by
a call mode V.22 modem (53.3 ms units).
0x09
S22 0x22 TSOL Transmit scrambled ones length. Length of time scrambled ones
are sent by a call mode V.22 modem (5/3 ms units).
0xA2
S23 0x23 VDDL V.22 data delay low. Delay between handshake complete and
data connection for a V.22 call mode modem (5/3 ms units added
to the time specified by VDDH).
0xCB
S24 0x24 VDDH V.22 data delay high. Delay between handshake complete and
data connection for a V.22 call mode modem (256
z
5/3 ms units
added to the time specified by VDDL).
0x08
S25 0x25 SPTL S1 pattern time length. Amount of time the unscrambled S1 pat-
tern is sent by a call mode V.22bis modem (5/3 ms units).
0x3C
Table 27. S-Register Summary (Continued)
“S”
Register
Register
Address
(hex)
Name Function Reset
Notes:
1. These registers are explained in detail in the following section.
2. The ring detector will only detect ringing if the ring burst on/off times meet the settings in MNRP, MXRP, MNRU, ROT,
and REP.
- Features 1
- Applications 1
- Description 1
- Functional Block Diagram 1
- 2 Rev. 1.3 2
- TABLE OF CONTENTS 3
- 1. Electrical Specifications 4
- Table 2. Loop Characteristics 5
- Table 3. DC Characteristics 6
- Table 4. DC Characteristics 6
- Table 5. AC Characteristics 7
- for K-Grade, T 8
- –40 to 85°C for B-Grade) 8
- = –40 to 85°C for B-Grade) 9
- 10 Rev. 1.3 10
- 3. Bill of Materials 11
- 12 Rev. 1.3 12
- 4. Analog Input/Output 13
- 5. Functional Description 14
- 5.1. Digital Interface 15
- 16 Rev. 1.3 16
- 5.3. Low Power Modes 17
- 5.4. Global DAA Operation 17
- 18 Rev. 1.3 18
- Rev. 1.3 19 19
- 20 Rev. 1.3 20
- 5.6. Loop Current Detection 21
- 5.7. Carrier Detect/Loss 21
- 5.8. Overcurrent Detection 21
- 5.11. PCM Data Mode 23
- Figure 10. Signal Routing 24
- 5.12. Analog Codec 25
- 5.14. V.42 HDLC Mode 26
- 5.15. Fast Connect 27
- Table 16. MCKR Configurations 28
- 6.1. Command Line Execution 29
- 30 Rev. 1.3 30
- 6.4. S-Register Control 31
- 32 Rev. 1.3 32
- 6.5.4. A1 34
- 6.5.5. !2 34
- 6.5.6. !7 34
- Table 19. !7 Parameters 35
- Figure 12. !7 Security Timing 36
- Progress 37
- S19 S1A S1B S16 S17 S18 38
- Table 23. DTMF 39
- 7.1. DSP Registers 40
- SE8 SE6 SE5 41
- DSP Reg. Addr 41
- 7.2. Call Progress Filters 42
- 8. S Registers 43
- 44 Rev. 1.3 44
- Rev. 1.3 45 45
- 46 Rev. 1.3 46
- Rev. 1.3 47 47
- 50 Rev. 1.3 50
- Rev. 1.3 51 51
- 52 Rev. 1.3 52
- Rev. 1.3 53 53
- 54 Rev. 1.3 54
- Rev. 1.3 55 55
- 56 Rev. 1.3 56
- 58 Rev. 1.3 58
- Kissoff Tone Detect Length) 58
- Rev. 1.3 59 59
- 60 Rev. 1.3 60
- Rev. 1.3 61 61
- 62 Rev. 1.3 62
- Rev. 1.3 63 63
- Rev. 1.3 65 65
- 66 Rev. 1.3 66
- Rev. 1.3 69 69
- 70 Rev. 1.3 70
- Rev. 1.3 71 71
- 72 Rev. 1.3 72
- Rev. 1.3 73 73
- 74 Rev. 1.3 74
- Rev. 1.3 75 75
- 76 Rev. 1.3 76
- Rev. 1.3 77 77
- DAA Isolation Barrier 78
- Emissions/Immunity 78
- DC Termination 79
- AC Termination 80
- Ringer Impedance 80
- DTMF Dialing 80
- Pulse Dialing 80
- Billing Tone Detection 80
- Symbol Value 81
- In-Circuit Testing 82
- Compliance Test Commands 83
- Introduction 84
- APPENDIX C—UL1950 3RD EDITION 85
- 9. Pin Descriptions: Si2400 86
- Rev. 1.3 87 87
- 10. Pin Descriptions: Si3015 88
- Receive Input 89
- Filter 2 89
- Pin # Pin Name Description 89
- 11. Ordering Guide 90
- Millimeters 91
- Revision 1.1 to Revision 1.2 92
- Revision 1.2 to Revision 1.3 92
- Rev. 1.3 93 93
- CONTACT INFORMATION 94
Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad V-Tec AT16/C5
(19 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.028 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales